Audio Or Linear Taper For Volume Pot - AUCAO
Skip to content Skip to sidebar Skip to footer

Audio Or Linear Taper For Volume Pot

Audio Or Linear Taper For Volume Pot. Not sure why, but i suspect it. It is a capacitor resistor circuit.

CTS 500k Split Shaft Volume/Tone Potentiometer Audio Taper or Linear
CTS 500k Split Shaft Volume/Tone Potentiometer Audio Taper or Linear from www.ebay.co.uk

After much experimentation, i’ve found that linear taper pots work best for my volume controls and audio taper pots are best for tone. With a linear taper pot, you will find that the volume increases slowly from 0 to about 60 or 70 percent, then increases rapidly from that point on. Tone pots should be linear tapered, but rarely are.

For Example, Rotating The Potentiometer To 50% Will Cause The Pot To Function At 50% Of The Maximum Resistance.


You want audio taper for that. Iff until 7 or so, on after that. Volume pots are always audio tapered;

Linear Pots Are Just That And Are More Used To Control Voltages, Etc In Circuits.


Open up your control cavity and look at the pot markings. Linear tapers can be good for adjusting lighting through light dimmers or for motion control. Jt, i put 4 bourns audio taper 500 tone n volume pots in my faded special sg with 50's wiring and a.022 and.

If You Use A Log Pot It's More Natural Of A Sweep For Volume.


Most people prefer them, at least for tone pots, because it spreads out the perceived effect of the tone change more evenly. Afaik tone pots should be linear taper. Linear pots adjust gain in a linear fashion, irrespective of how volume is perceived, which has the effect on the ear of a steep curve where anything less than 7 is essentially off.

Regular/Common Audio Taper Is 10% Or 10/90.


It's not a matter of preference, it's a matter of functionality. 1 meg audio taper amp pot with switch for vintage amps. 1 meg audio taper amp pot with switch for vintage amps.

Most People Suggest The Opposite Because They Are Confusing An Amplified Circuit With An Rc Circuit.


Linear taper pots should roll off the highs in an even, more controllable way. My preference is for my volume pots to start at 0 and when i roll em on like for swelling, they roll evenly. The tone of your guitar is not an amplifier circuit where an audio taper would come into play.

Post a Comment for "Audio Or Linear Taper For Volume Pot"